Sanden SN3500, Руководство по установке

Страница: 95 / 150

Appendix E: Checkout Procedures
82005-IM-K Sandel SN3500 Installation Manual Page 11-9
11.1.14 Flight Control System Interface
If the SN3500 is interfaced to a flight control system (FCS):
Place the FCS mode selector in heading (HDG) mode. Verify that the aircraft
controls respond correctly as the heading knob is turned and the heading bug
moves around the SN3500 display.
Completed _______ Comment __________________________________
Place the FCS mode selector in nav-coupled (NAV) mode. Verify that the aircraft
controls respond correctly as the course select knob is turned and the course
pointer moves around the SN3500 display.
Completed _______ Comment __________________________________
Switch sequentially through all the NAV sources and verify that the autopilot L/R
and U/D (if applicable) signals responds correctly to the selected receiver.
Completed _______ Comment __________________________________
11.1.15 Stormscope ® Interface
If the SN3500 is interfaced to a WX-500 remote lightning sensor:
Enable the Stormscope® display by within the WX menu. Verify that “WX” is
annunciated on the SN3500 display.
Completed _______ Comment __________________________________
Press M and then WX and select “WX TEST”. Verify that the word “TEST” is
annunciated on the SN3500 display for approximately 10 seconds, and is then
replaced by “WX”.
Completed _______ Comment __________________________________
11.1.16 Traffic