Cal Amp 4230, Руководство по программированию

Страница: 1 / 10

Installation of CalAmp 4230 Device for use with
VisTracks, Inc.
Note: The first few instructions below is for an initial connection to the CalAmp 4230 device. If
you have already paired the CalAmp 4230 device to your phone or tablet, proceed to Step 4.
Step 1 – Connect the device using an CalAmp 4230 to
​ ​
Jpod Y-cable 5C909-2
REV C.
1. The device plugs directly into the Jpod adapter cable. The cable then plugs into the vehicle’s
J1939 socket. The device does not need special prerequisites or installation from authorized
personnel.
2. After the device is plugged into the socket, the yellow and red LED starts blinking with 1Hz
rate. This means the device is powered and operational.
Step 2 – Enable Bluetooth functionality on your Android phone or tablet.
1. F ​
rom the main screen, Go to Settings.
2. Tap Bluetooth (under connections).
3. Tap the switch for “OFF” to “ON” position to turn on Bluetooth and put your Android
phone or tablet into pairing mode.