User's manual
Rotary Snow Blower
Tornado
-
14
-
2
1
3
2
3
a)
b)
In order to remount the catch (
1
), loosen and then unscrew two mounting bolts (
2
) which
secure it on machine's body (
3
). Once bolts are taken out of mounting holes take the catch out of
body's hollows as shown on
Fig. 9a
, and then place it again into the same hollows from machine's
opposite side (
Fig. 9b
) –
for Tornado 250
. Once the catch is properly set in the body, place in and
tighten mounting bolts.
Fig. 9.
Replacing catch
Tornado 250
Once operation is over, clean the machine and if need be put it aside in a rest place
previously setting sliding skids so that the blower upon its lowering onto the ground rests stable on
a cleaning blade and skids. In order to dismount the machine and tractor perform the described
steps in reverse order as in case of mounting, while hang the telescopic articulated drive shaft on a
corresponding holder, which can be found on the catch.
NOTE!
Use only genuine pins and cotters to mount blower on tractor.
NOTE!
The manufacturer shall not bear any responsibility for blower’s damages
resulting from improper mounting to tractor. Blower’s proper mounting
should be inspected periodically when operating.
5.2.
Mounting telescopic articulated shaft
NOTE!
Prior to mounting telescopic articulated shaft turn tractor's engine off and
take ignition key out. Do not allow any unauthorized personnel to access
tractor also.
NOTE:
Use telescopic articulated shaft and maintain its technical condition in
accordance with respective manual.
