Saluki S3302SB, Руководство пользователя

Страница: 186 / 199

Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com
186
Chapter XI Location Analyzer Mode (optional)
Section 1 Introduction to Typical Measurements
The location analyzer mode is mainly used for the positioning function of the interference source or the unknown
signal source, and the orientation of the interference signal can be quickly realized by using the external receiving
antenna and the electronic compass.
This mode requires an optional receiver antenna and an electronic compass option. Since the azimuth measurement of the electronic compass used in the
orientation analysis uses the principle of geomagnetism, please try to keep a distance from the magnetic object when testing.
The location analyzer mode mainly includes three measurement modes:
1 Point Scan
Below is an example of the point scan mode, mainly involving the following procedures.
1) Press [Measure]→[Point Scan], select point scan measurement mode.
2) Press [Freq]→[Pot Freq], set point frequency value.
3) Press [BW]→[BW], set bandwidth value, the bandwidth is set as s 150Hz, 300Hz, 600Hz, 1.5kHz, 2.4kHz, 6kHz,
9kHz, 15kHz, 30kHz, 50kHz, 120kHz or 150kHz.
4) Press [Swp/Ant]→ [Recall Antenna], select the antenna factor file.
5) Press [Demod], set the demodulation type and volume.