Saluki S3302SB, Руководство пользователя

Страница: 148 / 199

Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com
148
The power cannot be set as the maximum value until the maximum holding function is enabled.
Fig. 8-1 Schematic Diagram of Channel Scanner
2
Frequency Scanner
Below is an example of the Frequency Scanner mode, mainly involving the following procedures.
1) Press [Sweep]→ [FScan] → [Start Freq], and set the center frequency of the starting channel.
2) Press [Sweep]→ [FScan]→ [Step Freq], and set the frequency step of the measured channel.
3) Press [Sweep]→ [FScan] → [Bandwidth], and set the bandwidth of the measured channel.
4) Press [Sweep]→ [FScan] → [Number of Channels], and set the number of measured channels. At most 20
channels can be measured at the same time.
5) Press [Sweep]→ [Display Graph Table] and enable the graph display mode.