Saluki S3302SB, Руководство пользователя

Страница: 152 / 199

Tel: 886.909 602 109 Email: sales@salukitec.com
www.salukitec.com
152
Section 3 Description of Channel Scanner Menu
1 Sweep menu
· [Channel Scanner]: Press [Sweep]→ [Channel Scanner], set the
channel scanner mode and activate [Channel Scanner] menu. You can
the channel parameters in [Channel Scanner] menu. Refer to [Channel
Scanner] menu.
· [Freq Scanner]: Press [Sweep]→ [Freq Scanner], set the frequency
scanner mode and activate [Freq Scanner] menu. You can the channel
parameters in [Freq Scanner]. Refer to [Freq Scanner] menu.
· [List Scanner]: Press [Sweep]→ [List Scanner], set the list scanner
mode and activate [List Scanner] menu. You can the channel parameters
in [List Scanner]. Refer to [List Scanner] menu.
2 Channel Scanner menu
· [Signal standard]: Press [Sweep]→ [Channel Scanner]→ [Signal Std],
and the existing signal standard list will pop up, including relevant menus
such as [Head], [Tail], [Page Up] and [Page Down]. Click [Done],
and select the corresponding signal standard.
· [Start Channel]: Press [Sweep]→[Channel Scanner]→[Start Channel],
and set the number of the starting channel. In this case, the starting
channel will be the initial channel of measurement and cannot be set until
the signal standard is selected.
· [Number of Channel]: Press [Sweep]→ [Channel Scanner]→ [Number
of Channels], and set the number of measured channels. At most 20
channels can be measured.
· [Channel Step]: Press [Sweep]→ [Channel Scanner]→ [Channel Step],
and set the step between the measured channels.
· [Bandwidth]: Press [Sweep]→ [Channel Scanner]→ [Bandwidth], and
set the bandwidth of the measured channel.