Salicru CV10-002-S2, Руководство пользователя

Страница: 27 / 104

Function Parameters 27 - 104
Function
code
Name Detailed instruction of parameters
Default
value
Modify
P00.16
AVR function
selection
0: Invalid
1: Valid during the whole prodecure
The auto-adjusting function of the inverter can cancel the
impact on the output voltage of the inverter because of the
bus voltage fluctuation. 1 ○
P00.18
Function
restore
parameter
0: No operation
1: Restore the default value
2: Clear fault records
Note: The function code will restore to 0 after finishing the
operation of the selected function code.
Restoring to the default value will cancel the user password,
please use this function with caution.
0
◎
P01 Group Start-up and stop control
P01.00 Start mode
0: Start-up directly . Start from the starting frequency
P01.01
1: Start-up after DC braking . Start the motor from the
starting frequency after DC braking (set the parameter
P01.03 and P01.04). It is suitable in the cases where reverse
rotation may occur due to the low inertia load during starting.
0
◎
P01.01
Starting
frequency of
direct start-up
Starting frequency of direct start-up means the original
frequency during the inverter starting. See P01.02 for
detailed information.
Setting range: 0.00~50.00Hz
0.50Hz
◎
P01.02
Retention time
of the starting
frequency
Set a proper starting frequency to increase the torque of the
inverter during starting. During the retention time of the
starting frequency, the output frequency of the inverter is the
starting frequency. And then, the inverter will run from the
starting frequency to the set frequency. If the set frequency is
lower than the starting frequency, the inverter will stop
running and keep in the stand-by state. The starting
frequency is not limited in the lower limit frequency.
0.0s ◎