© Sage Instruments 2000
9100-2930-02 01/31/00
5-18
Section V Option Menu Numbers
Option Menu #:
4
You can add line signalling events to your sequence as well as digit records. Of these events, the 930i
can send them in
TERMINATE
mode or recognize and measure them in
BRIDGE
mode (Mon1&2 and
PCM). These events are:
WINK
A single line signalling pulse. A W is added to the sequence at the receiving end to send
a wink when it is ready to receive a digit record from the originating end. A wink must
be less than 600 msecs or the event will fail. (Refer to OPTION MENU #:9, Wink
Timing.)
OFF-HOOK
The condition where the receiver or handset is off the switch. An H is added to the
sequence at the receiving end to send an off-hook signal to the originating end. An off-
hook must be more than 200 msecs in duration or the event will fail. (Refer to OPTION
MENU #:9, Wink Timing.)
PAUSE
A pause of one second before proceeding. Use this when terminating a call, never
when monitoring. A PAUSE appears as a - in the sequence.
D-DIAL
A signalling event that tells the terminating end to go on-hook when ready to receive
digits. It is used for delay dial lines, and appears in the sequence as a D.
TESTLINE
Tells the 930i to go off-hook at the end of a call and simulate a test line. Available
testlines are:
100
-the 930i goes off-hook and provides quiet termination.
102
-the 930i goes off-hook and sends 1020 Hz at -16 dBm.
105
-the 930i goes off hook and acts as a type 105 responder.
LOOPBACK
-the 930i goes off-hook and acts as a loopback testline.
To set the sequence at the 930i operating as a digit receiver:
1. Press K3 under
SEQUENCE
. The default display reads:
WINK OFF-HK MORE
K1
K2
K3
K4
2. Use the numeric keypad to enter the number of the registers (1-4) where you want to store the
incoming records received from the send end. Pressing K2 under
WINK
tells the 930i to send
a wink (
W
) to the send end; pressing K3 under
OFF-HK
tells it to send an off-hook (
H
).
For the Immediate Start trunk or a Ground Start trunk not in TERM mode, a wink is not necessary.
3. Press K4 under
MORE
. The display reads:
PAUSE D-DIAL TESTLINE
K1
K2
K3
K4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Содержание 930i
