© Sage Instruments 2000
9100-2930-02 01/31/00
2-2
Section II Preparing For Operation/Power-Up
Preparation for
Operation
2-2 DC POWER VERSION
The table shown below describes the components of the 930i (DC power version) rear panel.
Barrier Terminal Block
Connects 930i to a -48V DC power supply
Fuse Holder
Holds a 2-amp Slo-Blo fuse. Turn 1/4 turn counterclockwise to open.
RS-232C Connector
Enables connection to Data Terminal Equipment (DTE).
ON/OFF Power Switch
Turns the 930i on and off.
Analogue
Rear Panel Access
Enables connection to a Jack Field from the rear panel.
PCM
Rear Panel Access
Enables connection to a Jack Field from the rear panel.
Fan Inlet
Provides ventilation to the 930i. Do not obscure fan inlet
(or outlet holes at the top right).
Remote Audio Jack
Enables remote audio connection to a trunk under test via a separate dial-up line.
The BNC jack enables the 930i to connect to an external clock source via a
coaxial cable.
External Clock
Chas
Gnd
Fan Inlet
Barrier Terminal Block
Fuse Holder
ON/OFF
Power Switch
Analog Rear
Panel Access
PCM Rear
Panel Access
Remote Audio Jack
9 Pin RS-232C
(DCE)Connector
External Clock
-48V
DC
Do Not Obstruct Fan Inlet
Power
ON
OFF
Analog
RS 232C
(DCE)
Fuse
5x20mm
3.15A
Ext Clk
PCM
) In
)Out
) In
)Out
1
2
T
R
T1
R1
E
M
SB
SG
Model Number: 930i Serial Number: 01234
Aux
240 AIRPORT BOULEVARD FREEDOM CA 95019 U.S.A. (408) 761-1000
Aux
INSTRUMENTS
2-3 SUPPLYING POWER AC/DC
1.
AC version
(if your back panel looks like the one on the previous page)
Connect the 930i to a 115/220 V AC power source via a 3-prong power cord. The power
connector is located next to the red ON/OFF rocker switch at the rear of the 930i.
Warning! If the rear panel of your AC unit does not look like the one on the previous page, you could
seriously damage your unit if you do not connect it to the proper power source. Older units,
which have a different rear panel and power supply, do not automatically switch between
115 V AC and 220 V AC operation but are equipped to operate only at a single voltage. You
must check your unit's power requirements before plugging it in and turning it on.
Table 2-2 Rear Panel (DC Power Supply)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Содержание 930i
