13
English
☞
Fig.12
☞
Fig.11
2
•
•
1
11
•
3
•
10
•
9
5 6
8
7
1
12
•
☞
4.10 Assembling coin acceptor
NOTE:
Only 12 V or 24 V parallel coin acceptors can be
installed.
- Remove the coin return panel ref.
1
(Fig.
11
).
- Take the universal panel (supplied with machine) and make a hole in the
middle to allow passage of the coin acceptor ref.
2
(Fig.
11
).
- Insert the coin acceptor (12 V parallel) and fasten it with the four screws,
nuts, and washers (supplied).
- Install the panel now assembled with the coin acceptor onto the machine.
- Connect the flat cable to the 10-pin connector on the coin acceptor ref.
12
(Fig.
11
) and to the other connector on the electronic board ref.
2
(Fig.
10
).
To prevent the machine from accepting one or more non-programmed
coins, change the position of dip switches ref.
11
(Fig.
11
). Shift the dip
switches of the channels to be locked into the up position.
The assembly of the coiner requires the removal of the panel ref.
3
(Fig.
11
) and the change button ref.
9
(Fig.
11
).
- Remove the support ring ref.
4
(Fig.
11
) from the back of the door
- Remove the bolt ref.
5
(Fig.
11
) and spring ref.
6
(Fig.
11
)
- Remove the lever ref.
7
(Fig.
11
)
- Open the support guides ref.
8
(Fig.
11
) and remove the knob ref.
9
(Fig.
11
)
- Remove the adhesive panel ref.
3
(Fig.
11
) and replace it with the universal adhesive panel (supplied) ref.
10
(Fig.
11
)
- Program the machine by setting the coin values equal to those accepted by the coiner. See PROGRAMMING pag. 19.
- Upon completion of the assembly, check the correct functioning of the coin mechanism.
NOTE:
If a 24 V coiner is used, it must be connected via a flat cable to the 16-pin connector marked G40
on the electronic board ref.
4
(Fig.
10
).
4.11 Assembling coin changer
NOTE:
The machine must be programmed with the same
protocol as that of the coiner. With a coin changer, the
machine can be programmed to give change or to
accept only exact change, according to the program
chosen. See PROGRAMMING.
- Assemble the coin changer ref.
1
(Fig.
12
) on the panel by hooking it to
the three pre-installed bolts ref.
2
(Fig.
12
).
- Connect the two coiner cables (fitted with connectors) to those already at-
tached to the machine.
For all other information pertaining to the actual coin changer, please refer
to the instruction manual accompanying the coin changer.
- Check the correct coin path by inserting several coins.
2
1
