Saeco BP 56, Использование и обслуживание

Страница: 34 / 36

English
34
Error code
ERROR 16
ERROR 22
ERROR 24
ERROR 25
ERROR 26
ERROR 27
ERROR 28
ERROR 29
Error message
DATA PROCESSING ERROR 1
FLASH PROGRAMMING ERROR
DATA PROCESSING ERROR 2
SAECO CARD WITHOUT TIME
KEEPER
COMPRESSOR WORKING FOR
MORE THAN 4 HOURS WITH FAULTY
INDICATOR
AMBIENT TEMPERATURE
INDICATOR FAULT
ALL MOTORS NOT AVAILABLE OR
FAULTY
FROST INDICATOR FAULT
Cure
Contact an Authorized Customer Service center.
Contact an Authorized Customer Service center.
Contact an Authorized Customer Service center.
Switch the vending machine off, install the TIME KEEPER
and switch back on.
This message is displayed after ERROR 27 has persisted
for 4 hours. Remove the cause that had produced
ERROR 27.
Switch the vending machine off. Check the indicator
connection and replace it if necessary. Switch the
vending machine back on.
Check the connections, reset the motor faults and contact
an Authorized Customer Service center if necessary.
Switch the vending machine off. Check the indicator
connection and replace it if necessary. Switch the
vending machine back on.
- wrap the vending machine in a sheet to protect it against
dust and humidity;
- store the vending machine in a suitable room (room
temperature must not be lower than 1
°
C). Do not place
any box or equipment on the vending machine.
9 OUT OF SERVICE
The vending machine will go “out of service” if an error or
a fault is detected which causes a function stop.
The display will read OUT OF SERVICE and show the code
(e.g. ERROR 15) corresponding to the fault that has
occurred.
If the cause of the problem is not removed by switching
the vending machine off and then back on, the vending
machine will remain out of service.
The following chart lists the displayed faults and possible
cures.
- remove and then reposition the corresponding left-hand
guide by carrying out the same operations. Make sure
that the left-hand guide and right-hand guide are
mounted at the same height;
- replace the tray and restore power input..
Important
The tray must be connected to the same connector as
before. Otherwise, the product sale parameters will have
to re-programmed (chapter 7).
8.9 Machine not in use or
machine storage
If the vending machine is not going to be used or has to be
stored for a prolonged period of time, carry out the
following operations:
- disconnect power to the vending machine ;
- empty all trays of any products;
- clean the vending machine according to the special
instructions of section 8.1;