English
23
7.4.2
Enter password
After entering the password, access can be obtained to
the next menu.
A default password is pre-set: <00000>, therefore, you
will not be prompted to enter your password.
Make a note of the new password if you change it.
7.4.3
Language
It allows to select the language to be used by the machine.
7.4.4
Price management
If the vending machine has been sold to a monolingual
country (France, Germany, etc.), after pressing the
programming key (Fig. 37), the machine display will read
PRICE MANAGEMENT.
The price of each available product selection can be set
from this menu (25 price settings are available).
For quicker management, one global price can be set (i.e.
all the selections will have one single price) with GLOBAL
SETTING. To change price for each individual selection,
go to the INDIVIDUAL SETTING menu.
When the clock module (TIME KEEPER) is installed on the
vending machine, 2 different prices, active at given times
only, can be set.
If the TIME KEEPER is not installed, only the ALWAYS FREE
(default option) and NEVER FREE functions can be set.
7.4.5
Payment systems
The following parameters can be set in this menu:
- Coin value
A value for each selectable coin (up to 6 denominations
are possible);
- Banknote value
A value for each selectable banknote (up to 4
denominations are possible);
- Protocol
The payment system protocols.
- Multivend
It allows to use possible residual credit to acquire other
beverages.
Setting “N” (no), the machine will store residual credit.
- Overpay time
It establishes the maximum time (expressed in seconds)
after which the machine stores the displayed residual
credit. It can be adjusted in 10-second steps. Setting
“000” the function is disabled.
- Card maximum recharge
It allows setting the card maximum creditable value
(Cashless systems). It is not possible to recharge cards
with higher values than the one set.
- Ref. Card
It allows to set a card maximum value. (Cashless
systems). Cards with higher values cannot be used.
- Point position
It allows to set the point position of the decimal in the
credit.
- Nation code
It allows setting the Nation code (international dialling
code).
- Scale factor
It allows to set the number of zeros fixed in the credit.
- Parallel coiner enabling
It allows enabling/disabling the parallel coiner.
- Banknote reader enabling
It allows enabling/disabling the banknote reader
- Reader inhibition level
It allows to set the banknote reader inhibition level (high/
low).
- Recharge enabling
It allows enabling/disabling the Saeco Card recharge.
7.4.6
System management
From this menu, you can set different system management
parameters.
- Vending machine code
To be assigned by the manager.
- Cold temperature:
It allows you to assign a service temperature of between
+6
°
C and +15
°
C to the refrigerating compartment.
Warning: the preset temperature can only be achieved
if the room temperature is between 1 and 32
°
and if
humidity is lower than 65% R.H.
Minimum temperatures apply to the three bottommost
trays and not to the top area of the machine where
snack products are usually dispensed.
- Text - Stand-by:
It enables to change the displayed message when the
vending machine is in stand-by.
- Text- dispensing:
It enables to change the displayed message during
dispensing by the machine.
- Text – Out of Service:
It enables to change the displayed message when the
vending machine is out of service.
- Reset Validation:
It enables to validate the maintenance menu data RESET
(partial counters).
