English
19
Fig. 37
7.4.1 Access to the programming
menus
Open the access door and disable the safety device (see
section 5.4) using the key kept by the
Maintenance
Technician.
Press the left-hand red button provided in the lower part
of the CPU card (Fig. 37), to obtain access to the
programming menus.
To quit the programming menus and return to normal
machine operation, proceed as follows:
- press the button shown in figure 38 once again, and
remove the key from the safety switch, in order to switch
the vending machine off;
- close the door and wait until the self-configuration
process has been completed.
7.3
Selection
By using the keypad, it is possible to select the product
seen in the showcase provided on the front door.
In the lower part of each tray is a label showing the product
code to select and the corresponding product price.
The keys to be used for selection are numbered from 1 to
9. Enter your required combination (23, 62, etc.),
corresponding to the choice of product to dispense.
This key
can be used to delete your selection in case a
mistake has been made.
If, during the self-configuration phase, faults have been
detected in the motors, or a spiral motor have been detected
as not available, after entering your selection, the display
will read the message: “
NOT AVAILABLE
”, which cancels
the corresponding selection.
If, during the dispensing phase, a motor becomes faulty,
the corresponding selection is disabled, and if this selection
is requested, the display will read the message “
NOT
AVAILABLE
” (until the cause of the trouble is removed,
and after starting the “
FAULT RESET
” procedur via the
maintenance menu).
7.4
Programming menu
Maintenance Technician
This section describes how to set or modify the vending
machine programming parameters.
It is therefore advisable to read this section thoroughly,
and only take action after having understood the exact
order of the required operations.
By following the procedures described in this chapter, it is
possible to set all the parameters concerning the vending
machine configuration and the product prices.
