RUSH PAR 1 RGBW user manual
10
Physical installation
The fixture is designed for indoor use only and must be used in a dry location
with adequate ventilation. Always ensure that none of the fixture’s ventilation
slots are blocked and always ensure that the product is firmly affixed to avoid
vibration during operation.
The fixture should be mounted or attached using the holes in its bracket.
Fastening the fixture to a flat surface
The fixture can be fastened to a hard fixed flat surface that is oriented at any
angle. Ensure that the surface can support at least 10 times the weight of all
fixtures and equipment to be installed on it.
Fasten the fixture securely. Do not stand it on a surface or leave it where it can
be moved or can fall over. Attach a securely anchored safety cable to the
fixture if it is installed in any location where it may fall and cause injury or
damage if the primary attachment fails.
Mounting the fixture on a truss
The fixture can be clamped to a truss or similar rigging structure in any
orientation. When clamping a fixture to a truss:
1. Check that the rigging structure can support at least 10 times the weight of
all fixtures and equipment to be installed on it.
2. Block access under the work area.
3. Rig the fixture using clamps and hardware suitable for the purpose.
Working from a stable platform, hang the fixture on the truss. Tighten the
rigging clamps and hardware.
4. Secure the fixture against clamp failure with a secondary attachment such
as an approved safety cable that is rated for the weight of the fixture and
affixed to the safety cable attachment point on the fixture (do not use the
mounting bracket).