RUMBLE HOG RH7500, Руководство по эксплуатации

Страница: 79 / 164

79
Section 3 - operation
Upper Rear Cameras
Two rear facing cameras mounted on the upper
rear of the debris tank provide an overhead view
of the pavement on each side of the cutter in sepa-
rate windows on the rear camera monitor. These
cameras provide the operator with the location of
the cutter and monitor cutting operations.
If the cameras are not mounted, use the following
procedure to attach the camera.
1. Attach each camera to the brackets on the
rear of the debris tank using the four bolts
and locknuts.
2. Tighten locknuts enough to secure the camera,
but allow for adjustment.
3. Set each camera to the desired angle and
tighten the locknuts securely.
4. Attach the cat 5 cable to each camera.
Lower Rear Cameras
Guidance Camera
A camera mounted below the chassis provides a
view of the pavement just forward of the cutting
drum in a separate window. An adjustable cross
hair on the screen is used for guidance and align-
ment purposes. Typically the cross hair is aligned
to the white line or a seam in the pavement to
help set the cutter at the proper offset and make
sure the cutter position setting is Maintained. The
cutter video also assists the operator in making
minor right/left cutter position adjustments during
cutting operations.
If the camera is not mounted, use the following
procedure to attach the camera.
1. Attach the camera and sunshade to the bracket
on the cutter camera bar using the four bolts
and locknuts. Tighten locknuts securely.
2. Loosen the friction knob on the camera mount
and slide the camera to the desired position
on the bar.
3. Set the camera angle and tighten the friction
knob.
4. If necessary loosen camera mounting locknuts
or swivel bolt locknut slightly to fine tune cam -
era angle. Then tight locknuts securely.
5. Attach the cat 5 cable to the camera.
Rear Video Cameras
Rear Guidance Camera
Verify Camera Operation
When all monitors and cameras are installed and
connected, activate each one and verify proper
operation. Correct any issues so each camera
system is operating properly before beginning
rumbling or planing operations.