RUMBLE HOG RH7500, Руководство по эксплуатации

Страница: 134 / 164

134
Section 4 - lubrication & maintenance
Debris Tank & Debris Tank Door
Vacuum Canister Filter & Service Port Plug
Weekly/50 Hour Maintenance:
• Inspect and lubricate door hinges and latches.
Use the following procedure to drain the can -
ister and remove and clean the vacuum filter:
1. Make sure the vacuum system is shutdown and
the truck is in the service position.
2. Open the filter access door and drain accumu -
lated water from the canister. Close the valve
when draining is complete.
3. Remove the wing nut that secures the filter to
the canister. Then remove the filter.
4. Use a detergent degreaser to cut oil and
grease, then power wash the filter with pres -
sure not exceeding 2000 psi (138 bars).
5. Thoroughly inspect the filter for holes and
damage. Replace the filter if its condition is
questionable, it is damaged or has holes that
could allow debris to get into the blower.
6. Install the cleaned or new filter and secure it
with the wing nut. Hand tighten the wing nut.
Make sure not to over tighten the wing
nut and collapse the filter.
7. Make sure the plug is secured in the filter ser -
vice port, then close and latch the access door.
NOTICE:
DEBRIS ENTERING THE BLOWER THROUGH THE FILTER
PORT CAN DAMAGE THE BLOWER. ALWAYS MAKE SURE
THE SERVICE PORT PLUG IS SECURED IN THE FILTER
BEFORE OPERATING THE VACUUM SYSTEM.
Debris Recovery Tank
Daily Maintenance: (When used)
• Check the water level sight tube for cracks or
damage and clean or replace as necessary.
• Check debris tank door seal to ensure good
sealing. Clean if necessary.
• Inspect hydraulic lift components and hinge
pins to ensure they are tight and in good
condition.