Ruijie RG-S2900G-E Series, Руководство по настройке

Страница: 78 / 943

Configuration Guide System Management Display Configuration
104 0% 0% 0% ssp_ipmc_hit_task
105 0% 0% 0% ssp_ipmc_trap_task
106 0% 0% 0% hw_err_snd_task
107 0% 0% 0% rerp_packet_send_task
108 0% 0% 0% idle_vlan_proc_thread
109 0% 0% 0% cmic_pause_detect
110 1% 1% 1% stat_get_and_send
111 0% 1% 0% rl_con
112 75% 80% 90% idle
As shown in the above, the first three lines indicate the total CPU utilization in the last
5 seconds, 1 minute and 5 minutes respectively, including LISR, HISR and task. Below
detains CPU utilization, where:

No: number

5Sec: CPU utilization in the last 5 seconds

1Min: CPU utilization in the last 1 minute

5Min: CPU utilization in the last 5 minutes

Process: process name
The first two lines indicate the CPU utilization of all LISRs and the CPU utilization of all
HISRs respectively. All the lines starting the third line indicate the CPU utilization of
processes. The last line indicates the CPU utilization of idle process. As with System
Idle Process under Windows, it indicates an idle status. The above example shows
that the CPU utilization of idle processes in the last 5 seconds is 75%, meaning that 75%
CPU is available.
Configuring CPU Log Limit Threshold
To configure the CPU log limit threshold, execute the following command:
Command Function
cpu-log log-limit low_num high_num Configure the CPU log limit threshold.
By default the upper threshold is 100% and the lower threshold is 90%.
The following example sets the lower threshold to 70% and the higher threshold to
80%:
Ruijie# configure terminal // Enter the global configuration mode
Ruijie(config)# cpu-log log-limit 70 80 // Configure the CPU logging trigger
threshold
If the CPU utilization is higher than 80%, the system prompts: