Ruijie RG-S2900G-E Series, Руководство по настройке

Страница: 690 / 943

Configuration Guide NFPP Configuration
The following example shows the describing information included in the sent
TRAP messages:
Failed to isolate host<IP=N/A,MAC=0000.0000.0004,port=Gi4/1,VLAN=1>.
It prompts the following message when the ARP scan was detected:
%NFPP_ARP_GUARD-4-SCAN: Host<IP=1.1.1.1,MAC=0000.0000.0004,port=Gi4/1,V
LAN=1> was detected. (2009-07-01 13:00:00)
The following example shows the describing information included in the sent
TRAP messages:
ARP scan from host< IP=1.1.1.1,MAC=0000.0000.0004,port=Gi4/1,VLAN=1> was
detected.
It saves the latest 256 pieces of records in the ARP scan table. When the ARP
scan table is full, it prompts:
%NFPP_ARP_GUARD-4-SCAN_TABLE_FULL: ARP scan table is full.
It prompts the following message to remind the administrator that the configured
rate-limit threshold is higher than the attack threshold:
％ ERROR ： rate limit is higher than attack threshold 500pps.”
It prompts the following message to remind the administrator that the configured
attack threshold is smaller than the rate-limit threshold:
％ ERROR ： attack threshold is smaller than rate limit 3 00pps.”
Caution

It sets a policy to the hardware when isolating the
attackers. When the hardware resources have been
exhausted, it prompts the message to inform the
administrator.

When it fails to allocate the memory to the detected
attackers, it prompts the message like
“
%NFPP_ARP_GUARD-4-NO_MEMORY: Failed to alloc memory.
”
to inform the administrator.

It contains only the latest 256 pieces of the records in the
ARP scan table. When the ARP scan table is full, the
newest record will overwrite the oldest one.