Roto-Jet 2200, Руководство по разборке и сборке, Страница: 30 / 41

2200 27
4.6.3 Thread the center guide and pick-up tube puller (P/N 0665285) into the
pick-up tube (1). Remember left-hand threads. Install two manifold guide
pins (P/N 0665030) into two ¾” holes in the endbell (26).
4.6.4 Thread the manifold lifting tool (P/N 060580638) into the manifold
discharge port. Lift the manifold (36) and lower over the center guide and
pick-up tube puller and the two manifold guide pins, being very careful not
to chip or damage the mechanical seal in the manifold.
4.6.5 Lower the manifold (36) until it registers on the endbell (26) with the
suction to the left.
4.6.6 Remove the manifold guide pins.
4.6.7 Using the center guide and pick-up tube puller, pull the pick-up tube (1)
into position in the manifold (36) being sure that the two pick-up tube
alignment pins (128) are in the correct position. Remove the center guide
and pick-up tube puller.
Note (1): Step 4.6.7 and 4.6.8 are best done with the pump in a horizontal position.
Note (2): Always inspect pick-up tube nut for any damaged threads or scratches, replace
if necessary. Remember the pick-up tube nut has left-handed threads.
4.6.8 Thread in four ¾” socket head cap screws (32) and torque to 240 ft. lbs.