Rotex E-Solar Unit ESU 509, Инструкция по установке и обслуживанию

Страница: 42 / 72

6 ROTEX control system ALPHA
+
23R
42
FA ROTEX ESU - 07/2008
6.6 System parameters
6.6.1 Setting parameters – Basic procedure
1. Set the "Default settings" rotary switch to the position .
Î
The display "PArA" lights up briefly. The display then alternates between the parameter number, shown on the left of
the screen (Figure 6-13), and the parameter value, shown on the right (Figure 6-14).
2. Use the and keys to select the required parameter.
3. Press the key to confirm your selection.
Î
The parameter value is displayed.
4. Use the and keys to modify the parameter value.
5. Press the key to save your entry.
Î The control confirms that the new value has been saved correctly by means of a programming confirmation on the
display: .
6. Leave the system parameters by resetting the rotary switch "default configuration" to the position or select another
parameter you want to change (steps 2 to 6).
Info value no. Info value Can be viewed by Comment
Installer Operator
E01 Fault no. 1 (most recent fault)
x x For fault codes, see the fault code table (Chapter 10.3).
E02 Fault no. 2
E03 Fault no. 3
E04 Fault no. 4
E05 Fault no. 5
E06 Fault no. 6
E07 Fault no. 7
E08 Fault no. 8
E09 Fault no. 9
E10 Fault no. 10 (oldest fault)
Tab. 6-6 General info values (part II)
Fig. 6-13 Parameter number display Fig. 6-14 Parameter value display
Parameters reserved for the heating technician are only accessible after entering the access code and thus,
visible for the heating technician (see section 6.6.4).
Up until the point when the parameters are saved, you can restore the original value by pressing the key and
holding it down for longer than 3 s. If the "Default settings" rotary switch is moved out of position before the
changes are saved, the value entered will be lost.
P05 60
OK
OK
OK