Rotary SL230RA-PE, Руководство по установке

Страница: 20 / 30

Installation Instructions ROTARY inground lifts SL230/SL235/SL2
50 • Release: 11/2013 • Page 20
8. Test run and handing over
8.1 Operational test
Drive the lift several times up and down and test proper function. Test all hydraulic connections for tightness and tighten up.
Activate emergency lowering function with air pistol and test lowering operation.
Purge again hydraulic cylinder until the oil escapes bulrush freely. Slope cylinders completely and fill oil level onto
maximum state. Protect hydraulic pump and all fittings in the installation cassette with wax spray against moisture.
Check the valve plugs on the hydraulic unit for humidity and protect against humidity using hydrophobic
grease.
Check the sealing at the foundation frame for cleanness and correct position.
8.2 Seal cover plate
Now insert cover plate and then seal the installation cassette between the frames and basic executions and/or cover plate
with the enclosed seal rubber. Employ some silicone in addition at the joints of the seal rubbers to avoid humidity coming
in.
For use in car wash or outside replace the seal rubber between frame and cover/basic execution
completely with elastic silicone.
8.3 Fixation of labels
Fix CE-sign and test sticker with country-specific time period at suitable site on the control box. Furthermore check the
manufacturers plate on top of the control box for existance and legibility.
8.4
Owners’ manual
Fill out the form “Initial installation by an expert“ within the owners’ manual and send it back to BlitzRotary GmbH:
FAX: ++49-(0)-771-9233-99
Complete the owners manual, sign it and hand it over to the owner.
Demonstrate the operable lift the operator, carry out an introduction by using the operating manual and in particular explain
the detailed operating manual.