Rotary SL230RA-PE, Руководство по установке

Страница: 9 / 30

Installation Instructions ROTARY inground lifts SL230/SL235/SL2
50 • Release: 11/2013 • Page 9
4. Installation of the power unit
4.1 Delivery situation
If the inground cassette was not delivered ´empty´, the hydraulic pump is completely pre-assembled inside the
cassette inclusive fixation support, cables and tubes and hydraulic oil. The connectors for the hydraulic hoses are
covered with a screw cap during transport. Furthermore, the pre-filled hydraulic pump is covered with a srew cap
during transport to protect from running out the oil.
4.2 Fixation of the hydraulic pump
Hang up the hydraulic unit into the side thread mounts of the in-ground cassette and attach with the screws (M10
with fixation teeth) contained in scope of delivery. Connect hydraulics hoses to the connections A and B of the
hydraulic pump according hydraulic plan HP20410(standard power unit 20410 for all models (fig. 6).
Fig. 6 Connections at power unit 20410
In principal it doesn´t matter which hose is connected to which connection. But the hydraulic
hoses have to hang free between synchronizing mechanism and outer wall of the installation cassette.
4.3 Remove transportation locking
Remove screw cap (fig. 7; transportation locking) at the pump at the oil filler pipe and screw in enclosed ventilation
screw (fig. 8). The ventilation screw is contained in scope of delivery inside the control box.
Fig. 7: Screw cap (yellow) only for transport Fig. 8: Bleeder screw (red) for use
It is not allowed to use the lift with transportation locking of the pump, because this can destroy
the pump!