Module Test
CTS60
1094.0006.60
11.2
E-4
Menu Ed.Mod.Test Type
This menu allows RF Signal Generator Settings in addition to external input and output attenuation
settings to be defined and associated against a particular “Module Test Type” entry. The settings for a
particular entry can be used at a later stage when Module Test is activated.
Any know attenuation settings that apply to the defined Mod Type should be defined at this stage. Input
and output attenuation settings can be associated with both RF connectors on an individual basis. The
fields relating to the RF Signal Generator setup within this menu will be discussed in more detail later in
this chapter.
11.2
Starting Module Test
Selecting DECT Module Test from the home menu, by pressing the “Start” softkey will display the
following menu. This is the basic starting menu for Module Test and allows some configuration settings
to be set prior to the activation of Module Test.
Menu Module Test
The “Burst Analysis” menu can be activated by pressing the “Start” softkey.
The front panel RF connector that is to be used with the device under test (DUT) can be set by pressing
the “RF Con” softkey.
Any custom input and output attenuation values associated with the individual RF Connector in use, can
be activated or deactivated using the “Coupler” softkey.
The user defined Module Test Type that will form the basis of the configuration data used for initialising
the Signal RF Generator in addition to any connector attenuation settings described above, can be
selected by traversing the list. The selected entry within the list will become the active configuration
when Module Test is started.
