Rockwell Automation Allen-Bradley PanelView 5510 Series, Руководство пользователя

Страница: 36 / 112

36 Rockwell Automation Publication 2715P-UM001C-EN-P - March 2019
Chapter 2 Install the PanelView 5510 Terminal
Connect to a Network The two Ethernet ports connect to controllers on an EtherNet/IP™ network by
standard Ethernet connections. These network topologies are supported:
• Device Level Ring Network Topology
• Linear Network Topology
• Star Network Topology
Each of these EtherNet/IP network topologies supports applications that use
Integrated Motion over an EtherNet/IP network, if necessary.
Ethernet Ports
The Ethernet ports have two 10/100Base-T connectors for network
communication and supports MDI/MDI-X connections and DLR network
topology.
The terminal connects to an EtherNet/IP network by using a CAT5, CAT5E, or
CAT6 twisted-pair, Ethernet cable with RJ45 connectors.
The maximum cable length between the Ethernet ports and a 10/100Base-T port
on an Ethernet switch (without repeaters or fiber) is 100 m (328 ft).
IMPORTANT The terminal has dual-Ethernet ports but one device IP address.
IMPORTANT To help prevent accidental disconnection of the Ethernet cable:
• To minimize vibration at the connector and help reduce the chance that
personnel working inside the panel can accidentally disconnect the cable,
secure the Ethernet cable to the connector.
• Do not install the Ethernet cable too tightly. To help prevent cable pull
when the panel door is opened and closed, leave some slack in the cable.
WARNING: In hazardous locations, do not connect or disconnect any
communication cable with power that is applied to this device or any device on
the network. An electric arc can cause an explosion in hazardous location
installations. Before you proceed, make sure that the power is off or the area is
nonhazardous.
Network Ports
Link 1 Link 2