Maintenance
Repair
MagneMover LITE Service Manual
67
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
10.
Store the motor in a secure location.
11.
See
to return the motor to MagneMotion.
Install the New Motor
1.
See the
MagneMover LITE User Manual
for detailed installation instructions.
A.
Transfer the motor mount from the old motor to the new motor. Install the pre-
viously removed M6 x 20 mm bolt and split lock washer, do not tighten the M6
bolt.
B.
Locate the motor so that the protruding boss on the motor mount is keyed into
the beam and aligned to the T-nut. Install the previously removed M8 x 20 mm
bolt and M8 split lock washer, do not tighten.
C.
Adjust the position of the motor along the beam so it is properly centered
where it is being installed.
D.
Tighten the M8 bolt to 26 N•m [230 in•lb] with a 13 mm Hex socket to secure
the motor mount to the beam.
E.
For aluminum rails, install the V-braces at all guide rail joints using M6 x 12
mm screws and tighten finger-tight to pull the rails together.
For stainless steel rails, install the V-braces at all guide rail joints using M6 x
12 mm screws with Loctite 243 and tighten finger-tight to pull the rails
together.
F.
Using fingers, align the rails at the motor joints and tighten the two M6 x 12
mm screws on each V-brace at that motor joint to 3.4 N•m [30 in•lb] with a
T30 Torx bit.
G.
Tighten the M6 bolt to 5.5 N•m [49 in•lb] with a 10 mm Hex socket to secure
the motor to the motor mount.
NOTE:
For stainless steel rails the Loctite must cure for 2 hours at 22° C
[72° F] before using the transport system.
2.
Reference the labels that were previously placed on the cables and connect the cables
to the new motor.
3.
Restore power to the section of the MM LITE transport system where the motor was
replaced.
4.
Program the masters and slaves on the new motor with the current Motor ERF Image
files (see
).
5.
Resume motion on the section of the MM LITE transport system where the motor was
replaced.
