Robox 3d printer, Руководство пользователя

Страница: 59 / 122

59 59
www.cel-robox.com
5.0 AutoMaker Software
•
Fill Density
This setting allows you to choose how ‘solid’ you would like the finished
object to be. The fill pattern can also be changed using a custom profile - see
section 5.5.6.
90% Fill 80% Fill 70% Fill 60% Fill 50% Fill 40% Fill 30% Fill
•
Support Material
This switch toggles the printing of support material. If you are printing a part
with large overhangs, you may wish to print structures at the same time
to support the object. Support settings (e.g. density and type) can also be
changed using a custom profile - see section 5.5.8.
•
Brim Width
‘Brim’ is a term applied to FFF (Fused Filament Fabrication) which describes
a large flat area which is printed around the part to help with bed adhesion
and warping. It can be easily trimmed off after printing, but may greatly
increase the success rate of prints with a small surface area at the base. This
number specifies the number of loops (and therefore the width) of the brim.