Robe ColorSpot 2500E AT, Руководство пользователя

Страница: 11 / 40

11
Effect-wheel:
1. Gently bend out the effect glass holder to release
it from the fixative holes and eject it from the pressing
snap.
2. Press the ends of the spring glass-lock together
with an appropriate tool and remove it. Remove the
glass and insert the new one.
. Press the ends of the spring glass-lock together
and insert it in the front of the glass.
. Put the glass effect holder back under the pressing
snap and push it to the 3 fixative notches.
CAUTION! The effect glass holder with the magnet must be placed in the same
glass position as it was placed before glass replacement!
5.6 Rigging the fixture
DANGER TO LIFE!
Please consider the respective national norms during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the fixture has to be built and constructed in a way that it can hold 10 times the weight for 1 hour without
any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This secondary
safety attachment must be constructed in a way that no part of the installation can fall down if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges, under high
working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert before
taking into operation for the first time and after changes before taking into operation another time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert after
every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled person
once a year.
Allow the fixture to cool for ten minutes before handling.
The projector should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to) calculating
working load limits, installation material being used, and periodic safety inspection of all installation material and the
projector. If you lack these qualifications, do not attempt the installation yourself, but instead use a professional structural
rigger. Improper installation can result in bodily injury and or damage to property.
The fixture has to be installed out of the reach of people.
If the fixture shall be lowered from the ceiling or high joists, professional trussing systems have to be used. The fixture
must never be fixed swinging freely in the room.
Caution:
Fixtures may cause severe injuries when crashing down! If you have doubts concerning the safety of a possible
installation, do not install the fixture!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the fixture’s weight.