Robe ColorSpot 2500E AT, Руководство пользователя

Страница: 33 / 40

window and the fixture will reset with the new software.
Note: In the case of interruption of the upload process (e.g. power cut), the fixture remains in the update mode and you
have to repeat the software update again.
For example: The fixture was switched off before finishing software upload. After switching the fixture on again, the fixture
is still in the update mode and the display is dark. Restart the Software Uploader program and repeat software update
from your PC.
10. Power down mode
This mode omits fixture reset after switching the fixture on and reduses motor powers of the fixture. „Power down mode”
is useful in special casech.g. if the fixture is in a flight case and you want to set its DMX address without taking it out from
the case. To enter „Power down mode”:
Press and hold [ENTER] and at the same time switch on the Power switch. The following message appears:
Realy Skip Initial Reset?
Escape/Enter
Press [ENTER] to activate „Power down mode” without fixture reset.Now you can set features and behaviour of the fixture
by using „Fixture Address” menu and „Personality” menu.It is expected,that this mode will be exited by switching the fixture
off, but if you want to go directly to „normal operation mode”, execute any fixture reset.
Note:
All motors in „Power down mode” are deactivated and switching the lamp on from the control panel is blocked.
11. RDM
This fixture supports an RDM operation. The RDM (Remote Device Management) is a bi-directional communications protocol
for use in DMX512 control systems, it is the new open standard for DMX512 device configuration and status monitoring.
The RDM protocol allows data packets to be inserted into a DMX512 data stream without adversely affecting existing
non-RDM equipment. By using a special „Start Code,“ and by complying with the timing specifications for DMX512, the
RDM protocol allows a console or dedicated RDM controller to send commands to and receive messages from specific
moving lights.
The ROBE DreamBox with an additional ROBE RDM-network software provides the RDM functionality. The DreamBox
supports RDM - new control protocol featuring AutoPatch and Fixture Status Monitoring.
The list of RDM commands for the ColorSpot 2500E AT is the following:
Parameter ID Discovery command SET command GET command
DISC_UNIQUE_BRANCH *
DISC_MUTE
*
DISC_UN_MUTE *
DEVICE_INFO *
SUPPORTED_PARAMETERS *
SOFTWARE_VERSION_LABEL *
DMX_START_ADDRESS * *
IDENTIFY_DEVICE
* *
DEVICE_MODEL_DESCRIPTION *
MANUFACTURER_LABEL *
DEVICE_LABEL * *
SENSOR_DEFINITION *
SENSOR_VALUE *
DISPLAY_INVERT * *
DISPLAY_LEVEL
* *
PAN_INVERT * *
TILT_INVERT * *
DEVICE_RESET *
DMX_PERSONALITY * *
DMX_PERSONALITY_DESCRIPTION *
STATUS_MESSAGES *
STATUS_ID_DESCRIPTION *
LAMP_STATE * *