Robe ColorSpot 2500E AT, Руководство пользователя

Страница: 30 / 40

0
Dimmer Curve - Select desired dimmer running.
Curve 1 Curve 2
CMY + CTF Curve - Select desired CMY f conversion temperature filter running.
Curve 1 Curve 2
Temperature Unit
--- Select this menu in order to display fixture temperatures in °C or °F.
Default Settings - Select this option to reset all fixture personalities to the default values.
9.4 Lamp On/Off
Use this option in order to switch on/off the lamp. It is also important to note, that the lamp is cold restrike type, that means,
that it has to be cold before striking.
9.5 Test sequences
Use this menu to to run a special demo-test sequences without an external controller, which will show you some possibili-
ties of using ColorSpot 2500E AT.
Mode 1 - This mode is suitable for projections on the wall, ceiling or ground without any head movement.
Mode 2 - This mode uses all ColorSpot 2500E AT functions including pan/tilt movement and therefore is
good for a complete introduction of the fixture.
9.6 Manual mode
Presetted Effects -
Select this menu to call up presetted positions of channel effects.
Manual Effect control -
Select this menu to control channels by control elements on the control board.
9.7 Stand-alone setting
Use this menu to set options for stand-alone mode as a selection of the playing program,programming and modifying
current programs.
Music Trigger - Select this function to enable the sound control of the running programs via the built-in microphone.
Presetting Playback - This function allows you to select the program which will be played in the
stand-alone mode after switching the fixture on.Selected program will be played continuously in a loop.
Disabled
- The option disables „Presetting playback” function.
Test Program - The option will start built-in test program.
Program 1 - The option will start created program No.1
Program 2
- The option will start created program No. 2
Program 3
- The option will start created program No.
Note: If the fixture operates in the controller mode (DMX controller is connected) and any program from this menu is
selected, in this case the fixture will not respond to the DMX controller after switching on and will play selected program.
Playing program
-Select this menu to run a built-in program or the freely-programmable programs in a loop.
Test Program In Loop - The option starts built-in test program.
Program 1 In Loop - The option starts created program No. 1
Program 2 In Loop -
The option starts created program No. 2