Robe ColorSpot 2500E AT, Руководство пользователя

Страница: 34 / 40

LAMP_ON_MODE 1
* *
DEVICE_HOURS
2
*
LAMP_HOURS 2 *
LAMP_STRIKES
2
*
1 ...Another options for this command (only for Robe´s fixtures):
value PARAMETER_DATA=0x - lamp OFF by DMX value on DMX channel
value PARAMETER_DATA=0x - lamp OFF if DMX is not present
2
...Commands relative resetable values
12. Error and information messages
Occured errors during fixture operation are signalized by warning icon on the display:
Press [ESC] to see the current error messages.
Description of the error messages:
Active Lamp Timer
This message appears if you try to switch on the lamp within 5 minutes after having switched it off (the lamp is too hot).
The message will appear on the display if the lamp doesn't ignite within 28 seconds. The ColorSpot 2500E AT will store
this information and automatically ignite the lamp when the 5 minutes period has expired.
Caution: The message is disabled if the lamp light sensor (function „Lamp Sensor” in menu Personality) is switched Off.
Lamp Error
The ignition of the lamp is seven times unsuccessful (the " Active Lamp Timer " message appeared six times before), and
the display shows " Lamp Error " , meaning that the lamp could be damaged or even missed or there could be a failure on
the ignitor or ballast.
Please place or replace the lamp and contact your dealer if the situation was not caused by the lamp.
Caution:
The message is disabled if the lamp light sensor (function „Lamp Sensor” in menu Personality) is switched off.
Overheated ->Lamp low
This message informs that the fixture head is overheated and the lamp power was reduced to 700 W.After 10 minutes the
lamp power will be switched to the full power.
Overheated ->Lamp Off
This message informs that the fixture head is overheated and the lamp was switched off by its temperature sensor.
Lamp Sensor Error
This message informs the lamp light sensor is failed.
Caution:
The message is disabled if the lamp sensor (function Lamp Sensor in menu Personality) is switched off.
Short Power Error
This message will appear if the fixture was shortly disconnect from the main.
Supply Frequency Error
This message will appear if the frequency of the main is not standard 50 or 0 Hz.This message can appear as a result
of the interference during the lamp starting (if the lamp or igniter is old) or as a result of the interference by neighbouring
devices. In these cases the message does not affect the fixture operating!
The following error messages are separated into 2 groups:
xxxx xxxx Error 1
(e.g. Colour Wheel Error 1 , Gobo 2 Index Error 1)
xxxx xxxx Error 2
(e.g. Colour Wheel Error 2, Gobo 2 Index Error 2)
There are some possible reasons of faults:
Message Characteristic fault
xxxx xxxx Error 1
Magnetic sensor is permanently On (e.g. leading wire is short-
circulated,defective stepping motor, defective control circuit on the PCB)
xxxx xxxx Error 1/xxxx xxxx Error 2 Magnetic sensor is permanently Off (e.g. leading wire is disconnected,
(together) defective magnetic sensor, missing magnet), defective stepping motor.