Rizzoli RP, Инструкция по эксплуатации

Страница: 78 / 148

ENGLISH
76
Picture 7 - Predisposition of the correct flue outlet
2.9 CORRECT CONJUNCTION TO THE CHIMNEY
If the conduct of the chimney starts from
a lower floor than the connection point of
the thermal cooker, it may be necessary to
close the conduct under the connection pipe
with fireproof materials. If you have the
chimney behind or up, you have to use the
connector with bayonet coupling. This must be inserted and turned so that it can remain
blocked. This connector has a tolerance of
about 1 cm to make the installation easier.
The tolerance is available according to
a single direction which depends on the
orientation of the connector (see picture 8).
If you have a lateral chimney in
correspondence of a side, the connector is
sliding. To install it correctly, it is necessary
to remove the cooking plate. Now, the
connector must be completely inserted
inside the wood fired thermal cooker or
the chimney, keeping the fixing buttonhole
on the same side of the thermal cooker. Then, you can place the wood fired thermal
cooker, extract correctly the connector so
that it connect the thermal cooker with the
chimney. Finally, bend the buttonhole and
block the parts with the screw-lock (see
picture 9).
Picture 8 - Tolerance for flue outlet on the top and back. The tolerance depends on the orientation of the connector.
+/-
10 mm
Y
X
+/-
10 mm