CO
2
NNEXT
rev.01
EN
63 / 293
1.
General information
1.1.General introduction
These assembly instructions are an integral part of the product CO
2
NNEXT (identified, in this document, with
the term partly-completed machine) produced by the company Rivacold s.r.l.; for this reason, they will need
to be part of the technical dossier of the final machine onto which this partly-completed machine will be
incorporated.
These instructions have been written to provide the technicians involved in the installation and maintenance
of the partly-completed machine with the essential information and instructions to operate correctly and
safely.
ATTENTION: Needing to be easily and immediately available, these instructions must be kept in a
place that is known and accessible to all.
NOTE: The purchaser may request a copy of this document (for example, in case of damage to the
original document) with a written request to the Manufacturer's Technical Office (see Section 1.7.1
"Request for Assistance"), engaging, in any case, to return the damaged copy.
1.2.Proprietary information
These assembly instructions contain confidential proprietary information. All rights
reserved.
These instructions may not be reproduced or photocopied, in whole or in part, without the prior written
consent of the Manufacturer. Only the purchaser may use this documentary material to whom the instructions
have been provided as a kit of the partly-completed machine and only for the purposes of installation and
maintenance of the partly-completed machine to which the instructions refer.
The Manufacturer declares that the information contained in these instructions is consistent with the technical
and safety specifications of the partly-completed machine to which the instructions refer. The drawings,
diagrams and technical data shown are updated at the date of publication of this document and are valid
only for the partly-completed machine to which they have been attached.
The Manufacturer reserves the right to apply changes or improvements to this documentation without prior
notification.
The Manufacturer assumes no responsibility for direct or indirect damage to persons, property or pets resulting
from use of this documentary material or of the partly-completed machine in conditions other than those
provided for.
1.3.Contents of the assembly instructions
These assembly instructions are intended for technicians in order to be able to understand and install the
partly-completed machine correctly.
In fact, these instructions provide, in addition to a description of the partly-completed machine, instructions
and indications for:
x
correct transportation and installation of the partly-completed machine;
x
performing of correct cleaning, adjustment and maintenance of the machine;
x
drawing attention to the most important safety and accident-prevention rules.
It is necessary to carefully read all the chapters in order to understand the indications provided in these
instructions and to operate with the partly-completed machine; for subsequent and easier searching through
the contents, refer to Table 1, containing a description of the topics addressed in the chapters.
