Rinnai 650, Руководство по эксплуатации и установке, Страница: 43 / 48

Rinnai 43
RDV 600_700 OIM
COMPLETING HEATER INSTALLATION
ATTACHING FASCIA ASSEMBLY
Step 12. Attach the Fascia to the Heater Engine
The fascia is mounted to the engine via three ( ,
& )
mounting points
located
within the heater engine
body
,
each of which contains a factory pre-positioned 8g (10mm) screw , remove and retain
all three screws
.
Carefully pick up fascia assembly and position it in front of the heater engine, connect the RJ45 plug into the
socket located on the back of fascia on the bottom left hand corner, (this connects the push button control panel
via a communications cable to the heater engine's control box).
Guide the tabs into the fascia assembly mounting slots and gently push the lower edge of the fascia
assembly until it is flush at all the edges.
Re-fit and tighten the three fascia retaining screws through the fascia and into the fascia mounting points
within the heater engine body.
These screws have been pre-inserted by the manufacturer to ensure correct threading of the
fascia securing points.
Ensure you DO NOT place excessive tension on or pinch the communication cable when
manoeuvring the fascia into position.
The glass of the fascia fitted to this appliance reduces the risk of fire and injury and no part of it
should be permanently removed.
For protection of young children or the infirm a secondary guard is required.
If the heater is not operating correctly refer to the “TROUBLE SHOOTING CHECKLIST” on page 17
before contacting Rinnai.
It is the responsibility of the installer to check that under normal operating conditions of the
appliance, all flue gases are exhausted to the outside atmosphere and that there is no spillage of
combustion gases into the room. Please refer to AS/NZS 5601.
During the initial burning in period of approximately 2 hours, some minor smoke and smell may
be experienced. During this period the heater should be operated on High and the space being
heated should be well ventilated. It may take up to 20 minutes of operation for the logs to achieve
their full flame pattern and glow.
Burner aerations are factory set and can NOT be adjusted. If you are unable to get the unit to
operate correctly refer to “TROUBLE SHOOTING CHECKLIST” on page 17 before contacting
Rinnai.
C
D
E
E
A
B
B
A
B
B
A
A
A
i
ii
iii
ii
B
iii
i
B
F
F
A
i ii iii
A
B
NOTE
C
D
E F
NOTE
C
B
A
NOTE
WARNING