Rinnai 650, Руководство по эксплуатации и установке, Страница: 36 / 48

Rinnai 36 R
DV 600_700 OIM
BURNER MEDIA INSTALLATION
CERAMIC LOG SET INSTALLATION
Carefully unpack and inspect each log for damage one at
a time, temporarily returning each of the logs to the
packaging for safe keeping until required. If
ANY damage
is evident on the logs DO NOT continue with installation
and contact your supplier for advice.
Step 1. Removing the Burner Box Glass
While supporting the burner box glass panel in place ,
unscrew and remove the four retaining screws . Once
unscrewed pull the burner box glass panel away and
place it and the retaining screws safely aside where the
glass and frame can not get damaged or the screws
become lost.
Step 2. Burner Inspection
Check to ensure that the ports of the burner are clean
and clear of any particles and all packaging material.
Step 3. Ember Bed Installation
Remove the stone guard , by unscrewing the three
retaining screws, then gently lift the stone guard out,
taking care to avoid scratching any of the interior surfaces
or fittings.
Fill the perforated ember tray evenly with the glass
ember granules , then take between 6 to 8 pieces of
the black burner granules and spread these randomly
over the glass layer of the ember bed.
When satisfied with the placement of the ember bed
material, carefully re-fit the stone guard
.
Step 4. REAR Log Installation
Identify the “REAR” log and then carefully remove it from
the protective packaging.
Locate the two slots in the base of the log and carefully
place these over the positioning pins
which are
located at the rear of the burner box, ensuring that the
detailed surface of the log is facing out to the front.
For clarity the drawings are displayed
without showing the entire heater.
Use extreme care when handling the
Ceramic Log Set components, they are
made from a very fragile high temperature
material and will damage if handled
roughly. Only remove the components
from their packaging as required using the
specific order as stated.
A set of instructions is attached to the
burner box glass that has pictures of the
suggested stone media placement, ensure
to retain this instruction for use with
“CERAMIC STONE SET INSTALLATION”
on page 38.
2
4
1
3
A
B
E
F
D
C
D
G
REAR log
i ii
iii
iv
v
RDV600
REAR
FRONT
RDV700
FRONT
REAR
MIDDLE
RIGHT
LEFT
LOG
i
ii
iii
iv
v
Artificial log set as supplied
in protective packaging
NOTE
NOTE
A
B
C
D
E
F
C
G