Rinnai 650, Руководство по эксплуатации и установке, Страница: 34 / 48

Rinnai 34 R
DV 600_700 OIM
HEATER ENGINE INSTALLATION
Step 6. Positioning the Heater Engine
Before installing the heater, check it is labelled for the
correct gas type, (refer to the gas type label on the top body
panel of the heater). Refer to the local gas authority for
confirmation of gas type if you are in doubt.
Place the heater engine in front of the fireplace enclosure.
Step 7. Connect Electrical Supply
Ensure that the external isolation switch is OFF before
connecting the power to the heater engine.
Step 8. Prepare Gas Supply
Remove the threaded brass plug from the S/S flexi pipe
consumer gas supply pipe.
Step 9. Insert Heater Engine Into Fireplace
Position the heater engine so that the outer edges of the
spigot plate
can be aligned with the guide rails on to
of the engine. Then Carefully move the heater engine into
the fireplace ensuring that the gas supply pipe and fittings
feed into the rear access hole and that the outer edges
of the spigot plate engage the guide rails .
Use two screw bolts located in the upper flange of the
heater to engage the nutserts installed in the front tab of the
spigot plate
.
Tighten these screw bolts, to pull the spigot plate
forward and allows the 6 locating / locking tabs
of the
engine to engage the corresponding holes of the spigot
plate and form a seal between the flue components and
the engine.
Step 10. Securing The Heater Engine
Fasten the heater to the masonry work using appropriate
fasteners (not supplied) using the three holes across the
top of the fascia assembly mounting panel and the 3 holes
on each side of the side panels as shown
.
Step 11. Connecting Gas
Continue to “CONNECTING GAS” on page 35.
A panel from the cardboard packing carton
placed on the floor underneath the heater will
help prevent possible damage to flooring.
On completion of heater installation DO NOT
allow any portion of the 100mmØ exhaust flue
to remain in contact with any combustible
materials. Flue temperature may be hot
enough to ignite certain materials.
Take care that the electrical cord does not
bunch up or get pinched behind the heater
engine while inserting the engine.
N
F
F
P
Q
M
Q
P
O
R
HINT
F M
N
F M
O
F
F
P
Q
F
DANGER
CAUTION
R