Rinnai 650, Руководство по эксплуатации и установке, Страница: 16 / 48

Rinnai 16
RDV 600_700 OIM
CARE AND MAINTENANCE
ERROR CODES
Your Rinnai Gas Fire is also
fitted with self diagnostic
electronics that monitor the
appliance during start-up
and operation.
Should a fault occur the
appliance will then shut
down, the fault that has
caused the shut down will be
indicated by a pair of
flashing digits in the Error
Display window
, which is
located behind the fascia
and can be viewed by
looking down between the
glass of the dress guard and
the burner box.
Refer to the table below for
probable cause and the
suggested remedy.
In all cases, you should be able to clear the Error Code on display simply by turning the heater
‘OFF’, then ‘ON’ again. If the Error Message still remains or returns on the next operation, contact
Rinnai or your nearest service agent and arrange for a service call.
Code Probable Cause Suggested Remedy
00 Mains power failure
Interruption to the power or gas supply will turn your heater off and a
restart will be required. This is a safety feature designed to ensure
that un-attended starts do not occur after power or gas interuptions.
Access the 'Push Button Control Panel' . This is located on the
front of the heater at the lower right hand corner.
Press ON / OFF button twice, afterwitch you will be able to hear
the ignition sparking and the heater will restart and return to normal
operation, after 30 seconds of operation the remote control may then
be used to select the desired flame height and fan speed.
11 Ignition failure
Check gas supply is turned on, switch the heater to Standby and
then On again.
If the error persists a service call will be required.
12 Incomplete combustion
Check gas supply is turned on, switch the heater to Standby and
then On again.
If the error persists contact Rinnai.
14 Filter Blockage / Overheat Clean filters, if the error persists a service call will be required.
16 Room overheat Lower room temp to below 40°C.
31 Room temperature sensor faulty A service call will be required.
32 Overheat temperature sensor faulty A service call will be required.
33 Overheat temperature sensor faulty A service call will be required.
53 Spark sensor faulty A service call will be required.
61 Combustion fan motor faulty A service call will be required.
71 Solenoids faulty A service call will be required.
72 Flame detection circuit fault A service call will be required.
73 Communication error A service call will be required.
WARNING
8
c
a 1
Error Code Viewing Window
7
7
7
1
a