Rinnai 650, Руководство по эксплуатации и установке, Страница: 14 / 48

Rinnai 14
RDV 600_700 OIM
REMOTE CONTROL OPERATION
REPLACING THE CR2450 BUTTON BATTERIES
When this low power symbol appears the batteries are
near to being fully discharged and are unable to power
the remote control properly. Replacement of batteries
is now required.
1. Using a suitable lever remove the back cover by carefully prying off
the back cover at the 6 pry points .
2. Remove the two bridge retaining screws using a small (No.0)
Phillips head screw driver .
3. Remove the bridge .
4. Remove the old batteries by carefully sliding them out from
under the retainers , and into the space that was created when
the bridge was removed in step 3.
5. Insert two new batteries (CR2450), ensuring the positive “
+
”
terminals are facing up.
6. Reassemble the bridge in reverse order as per steps 2 & 3 above.
7. Re-attach the rear cover by carefully clipping it back into place.
LOST, MISPLACED OR BROKEN REMOTE CONTROL
In the event of a lost, misplaced or broken remote control the appliance
may still be operated in a limited capacity. By using the power ON/OFF
button located on the front of the heater at the lower right hand corner.
The heater will automatically modulate between flame settings to maintain the default set temperature of 22°C. No
control of the flame or heat output is possible via the appliance ON/OFF button.
The back cover is not shown in these illustrations.
g
g
j
i
j
h
i
f
f
NOTE
g
h
i
j
h
i
b a 1