RIKA INTEGRA II, Руководство пользователя

Страница: 23 / 37

Copyright © 2008 by Lucky Distributing Revision 2.0 updated 11/05/2008
23
BASIC OPERATION
DO NOT start your stove until the venting
installation is complete
NOTE:
Your pellet stove is exclusively for burning
pellets made from wood of a controlled quality.
Non-pelletized solid fuels (straw, corn, chopped
matter, etc.) should not be used. Failure to adhere
to these guidelines will void your warranty.
NOTE: When operated correctly, your pellet stove
will not overheat. Improper operation can shorten
the life expectancy of the stove and its components.
ATTENTION : Your stove’s automatic ignition
system will not work properly if either the hopper lid
or combustion door are open.
CONTROL UNIT PROGRAMMING AND
FUNCTION
Your pellet stove is equipped with a modern
programmable control board and control software.
The owner can set all equipment functions via the
control keypad which is found on the right hand side
of the unit. The control board and software should
only be altered by trained specialists. Improper or
unauthorized changes to your stove, unless outlined
in your owner’s manual, will void your warranty.
Possible Operating Modes
Pressing ENTER on the control panel enables the
user to change between each of the three different
operating modes.
•
Manual Mode - press the power button to
turn the unit on and off.
•
Automatic or Timed Mode (TM) - runs
according to a schedule that you determine.
•
Standby Mode (SB) - waiting for you to
change to one of the other two modes by
pressing the “Enter” button on the key-pad.
No function, other than programming, can
occur in this mode.
Control Keypad
All settings and functions can be regulated via this
unit.
DISPLAY BOX
Displays the operating modes in illuminated letters
and numbers.
MENU
Used for navigation in and to the different menu and
sub-menu levels.
ENTER
Used for navigation through the main menus (SB,
ON, TM) and for confirming user entries.
MINUS & PLUS
Used for lowering or increasing heat output levels
and for changing program values.
POWER
Used for turning the unit on and off.
TURNING YOUR STOVE ON AND OFF
To operate your stove manually, place it into
manual mode (see the “POSSIBLE OPERATING
MODES” section).
Once in manual mode, the stove is turned on and off
by pressing the power button. Heat output is
controlled by pressing the “+” and “–“ buttons.
Your RIKA pellet stove is equipped with an electronic ignition start-up system. Starter fluids or gels are not necessary and
should never be used. Simply push the power button and the unit will ignite within a 12-minute period of time. Total start-up
cycle time is 21 minutes.
Menu
Minus
Power
Digital Display
Enter
Plus