RIKA INTEGRA II, Руководство пользователя

Страница: 29 / 37

Copyright © 2008 by Lucky Distributing Revision 2.0 updated 11/05/2008
29
scraper rod
tool
MAINTENANCE AND CLEANING
•
Do a final vacuum of the entire combustion area to remove any additional ash or debris.
Re-Assembly
•
Re-attach the top and lower cast iron wall plates (attach the top piece first).
•
Re-seat the ash pan and burn pot, making sure that the burn pot is fully seated in place.
•
Close the door.
•
Plug unit back into wall outlet. Your stove is now ready for normal use.
Heat Exchanger Baffle Tubes
A primary component of the heat exchanger system is a series of baffle tubes located behind the
interior cast iron walls of the combustion chamber. As fuel is consumed, ash builds up on these baffle
tubes which reduces the heat transfer capability of your stove. It is recommended that you clean the
exchanger baffle tubes no less than one time per day, and every time you add fuel. Regular cleaning
of the baffle tubes will ensure that the heat exchanger system is working optimally and that you are
getting the greatest amount of heat output possible from your stove.
Cleaning is accomplished by pulling up and pushing
down on the two exchanger scraper rods that
protrude out of the top of the stove. These rods can
be found on the very top of the stove underneath the
colored accent panel. There are two holes in the
accent panel where the rods recess into. Due to the
placement of these two holes, actual removal of the
colored accent panel is not necessary for cleaning.
A scraper rod tool was provided with your stove (see
image) that is specifically intended for cleaning the
exchanger baffle tubes. The two scraper rods
described above have a hole at the very top where
this tool “hooks” into. Simply hook the tool into each
of the two respective rods and pull up/push down
two to three times per cleaning.
NOTE: When the stove is hot you may feel resistance when you pull up/push down on the rods. This
is normal and occurs as a result of expansion of the stainless steel baffles tubes as they get hot.
NOTE: Any time the stove is on, the scraper rods will be very hot. Do not touch them with your bare
hands or you could be burned. Use the oven mitt that was provided with your stove, or other suitable
hand protection, before touching any of the metal surfaces of your stove.
Removal or Replacement of Broken Door Glass or Damaged Door Seals
If the door glass becomes damaged in any way, including actual damage to the glass or to one of the
gaskets on the door, replacement of the damaged area should occur prior to operating the stove.
While wearing leather gloves, carefully remove any loose pieces of glass from the doorframe. Dispose
of all broken glass properly. Return the damaged door to your dealer for replacement or have your
dealer do an on-site replacement of the affected area.
In order to maintain proper materials, installation, fit, and any required edge clearances, all repairs or
replacement involving door glass, gaskets, or any cushioning devices or components should be
performed only by an authorized service technician.