RIKA INTEGRA II, Руководство пользователя

Страница: 19 / 37

Copyright © 2008 by Lucky Distributing Revision 2.0 updated 11/05/2008
19
MOBILE HOME INSTALLATION
In addition to standard installation instructions,
the following requirements are mandatory for
installation in a mobile home:
1. The unit must be permanently bolted to the
floor.
2. The unit must have a permanent outside
air source.
3. The unit must be permanently electrically
grounded to the steel chassis of the home.
4.
Use silicone to create an effective vapor
barrier at the location where the chimney or
other component penetrates to the exterior
of the structure.
For use in mobile or manufactured homes,
the stove must be installed in accordance
with the Manufactured Home and Safety
Standard (HUD), CFR32 80, Part 24.
Design guidelines for outside air
connection
1.
A connection to the outside is REQUIRED
for mobile home installations.
2.
Only metal pipe with a minimum two inch
diameter is approved for use as an outside
air connection (straight or flexible). PVC
pipe or aluminum pipe is NOT approved
and should never be used.
3. The air inlet must be terminated with a
vertical 90 degree bend (down) or with a
wind hood.
4. Blockage, excessive length, or bends in the
air intake will starve the unit of combustion
air.
Minimum diameter 2inches
2”
3”
6”
WARNING:
DO NOT INSTALL IN SLEEPING ROOMS.
COMBUSTION AIR MUST COME FROM THE OUTSIDE
OF THE MOBILE HOME.
CAUTION:
THE STRUCTURAL INTEGRITY OF THE
MANUFACTURED HOME FLOOR, WALL AND
CEILING / ROOF MUST BE MAINTAINED.
THIS STOVE IS TO BE CONNECTED TO A FACTORY-
BUILT-CHIMNEY CONFORMING TO CAN/ULC-S629,
STANDARD FOR 650
C
FACTORY-BUILT CHIMNEYS.
COMPLETELY REMOVE EXTERIOR PORTIONS OF
CHIMNEY PRIOR TO MOVING THE MOBILE HOME.
90 degree bend termination
Wind hood termination
wind hood
A 90 degree bend is equivalent in restriction five
fee of straight pipe.