RIKA INTEGRA II, Руководство пользователя

Страница: 30 / 37

Copyright © 2008 by Lucky Distributing Revision 2.0 updated 11/05/2008
30
TROUBLESHOOTING
CAUTION: FOR ANY TROUBLESHOOTING PROCEDURE THAT REQUIRES YOU TO OPEN THE
DOOR, THE STOVE SHOULD FIRST BE SHUTDOWN AND ALLOWED TO COOL PRIOR TO
PROCEEDING.
PROBLEM
The fire is burning with a weak or orange flame, the flames have black tips, pellets are collecting
in the burn pot, the window is glazing.
CAUSE:
Inadequate combustion air.
POSSIBLE SOLUTIONS:
•
Make sure that the unit has been cleaned. See the Cleaning and Maintenance section of this
manual.
•
Verify that the burn pot is correctly seated in place.
•
Remove any ash or clinker that may be blocking the air inlet openings in the burn pot.
•
Change to a better pellet quality.
•
Verify that the flue pipe is not blocked with ash. The flue should be cleaned by your dealer at
least one time every two tons of fuel, or annually whichever comes first.
•
Verify that the air inlet is clean and free of debris. Dust and animal hair can collect on the air
sensor and cause the sensor to send false readings to the control system.
•
Check door seal by closing a dollar bill in all four sides of the door. When pulling on the bill you
should have equal resistance on all four sides. If not, consult your dealer for adjustment.
•
Verify that sufficient air flows into the home. This can be verified by opening a window or door. If
the flame quality improves, an outside air kit may be necessary.
PROBLEM
The fire goes out and the stove switches itself off automatically.
CAUSE(S):
•
Pellet hopper is empty.
•
The burn pot is not seated properly.
•
The Hi-Temp safety switch was triggered due to excessive temperature.
•
The door seal is not tight, is damaged, or the door is not closed properly.
•
Poor pellet quality.
•
Pellet feed rate too low.
•
The Low-Limit switch was triggered due to low temperature.
•
Clean-out openings are not closed properly or component seals are not sealed properly.
POSSIBLE SOLUTIONS:
•
Fill the hopper with pellets.
•
Re-seat the burn pot.
•
Perform routine maintenance and cleaning.
•
Change the brand of pellets used and only use premium pellets.
•
Increase the heat output level.