RIKA INTEGRA II, Руководство пользователя

Страница: 15 / 37

Copyright © 2008 by Lucky Distributing Revision 2.0 updated 11/05/2008
15
INSTALLATION
CANADIAN INSTALLATION
Where passage through a wall, or partition of
combustible construction is desired, the install
shall conform to CAN/CSA-B365.
Clearances may only be reduced by means of
approved regulatory authority.
This appliance requires a full reline when installing
into a masonry fireplace.
Where passage through a wall, or partition of
combustible construction is desired, the install
shall conform to CAN/CSA-B365.
Clearances may only be reduced by means of
approved regulatory authority.
A pre-existing fireplace shall not be modified to
accommodate installation.
WARNING:
Do not remove any brick or mortar from an
existing fireplace to accommodate installation of
the stove.
Exceptions: Masonry or steel, including the
damper place, may be removed from the smoke
shelf and adjacent damper frame if necessary to
accommodate a chimney liner, provided that their
removal will not weaken the structure of the
fireplace and chimney, and will not reduce
protection for combustible materials to less than
that required by the National Building Code.
This fireplace insert must be installed with a
minimum 3” continuous chimney liner extending
from the fireplace insert to the top of the chimney.
The chimney liner must conform to the Class 3
requirements of CAN/ULC-S635, Standard for
Lining Systems for Existing Masonry or Factory
Built Chimneys and vents, or CAN/ULC-S640,
Standard for Lining Systems for New Masonry
Chimneys.
The chimney damper may be removed to
install a chimney liner.
Connect your stove to the chimney liner according
to the chimney liner manufacturer’s instructions.