RIEXINGER BSM 630, Руководство по эксплуатации

Страница: 43 / 70

8. Finding an reparing malfuncitons 41
8. Finding an reparing malfuncitons
8.1 Repair saw-band malfunctions
Danger!
Running saw band may cause serious severance injury!
l
Before repairing a malfunction, turn off machine with main swith so the
motors are not accidentally turned on.
l
The malfunctions may only be repaired by one person at a time.
Warning!
Running saw band may injure the operator!
After releasing push buttons on the handle or deactivating the main switch , wait
until the saw band has come to a complete stop before entering the saw-band
area.
Malfunctions associated with the saw band, usually occur during the sawing process. Go
through the table from top to bottom when searching for the cause of the malfunction.
Malfunction Cause Corrective action
Saw band "displaced" or
pushed up by the work-
piece that is being sawed
Saw band jumps off
diversion-wheels
Saw band torn
Saw-band tension not properly
adjusted Set proper saw-band tension (see
Chap. 9.2 on p. 49)
Saw feed rate too high
Reduce saw feed rate (see Chap-
ter 1.1 on p.1)
Saw band dull
Exchange saw band (see Chap.
9.3 on p. 50)
Saw band installed in wrong
direction Properly installing a saw band
(see Chap. 9.4 on p. 51)
Defelction wheels or saw band
guides are dirty
Clean deflection wheels and saw
band guides (see Chap. 9.1 on p.
48)
Deflection wheels or saw band
guides are set incorrectly
Set deflection wheels and saw
band guides (see Chap. 9.5 on p.
52)
Saw band does not have nec-
essary properties.
Use original saw-band from the
manufacturer (see Chap. 3.4 on p.
16)
Workpiece has unsuitable mate-
rial type (see Chap. 3.5 on p. 16) Consultation with the man-
ufacturer (see Chap. 8.5 on p. 46)
Saw band jammed in
workpiece
Used wrong saw-band type
Consultation with the man-
ufacturer (see Chap. 8.5 on p. 46)
BSM 630