RIEXINGER BSM 630, Руководство по эксплуатации

Страница: 41 / 70

7. Operation 39
Warning!
Start sawing process only after engine has reached final speed!
l
To avoid interference during sawing process wait after starting saw band
until motor has reached full rotational speed. Then start with sawing pro-
cess.
1) Push saw bow in it's rear home position.
2) If required, set the desired sawing angle (see Chap. 7.4 on p. 34).
3) Load the workpiece and fasten it (see Chap. 7.5 on p. 35).
4) Turn on machine at main switch (see Chap. 7.3 on p. 33)
5) Press push buttons at the handle of saw bow. Saw bow starts.
Information
If you want to interrupt the sawing process, just release the push buttons of the
handle.
l
The motor of saw band stops.
6) Pull saw bow forwards slowly.
Info
To reach a optimum cutting result, start cutting the workpiece slowly.
l
Do not burden machine and sawband with excessive feed rate.
l
Only use sharp saw bands.
7) If the workpiece is completely cut, release the push buttons . The saw band drive stops.
8) Push saw bow back in rear home position.
BSM 630