RIEXINGER BSM 630, Руководство по эксплуатации

Страница: 30 / 70

28 6. Setup and activation
Pos. Description
1 Machine base frame
2
Mounting plate at back side of swivel frame with 6 holes for mounting screws and one
pin hole for pin
3 Mounting plate at saw bow with 6 holes for mounting screws and one pin for pin hole
4 Adjusting screw upper stop
5 Upper stop
6 Lower Adjusting screw saw bow
7 Upper Adjusting screw saw bow
8 Flap with hole to mount the springs
1) Lift and secure the saw bow with a suitable lifting gear or crane.
2) Place the saw bow with the mounting plate (2) carefully on the mounting plate (3) at swivel
frame on the backside of the machine.
3) To secure the position you push the pin into the pin hole and insert the 6 bolts (M10) to. The
pin also serves as a swivel joint.
4) With the upper and lower adjusting screw (6 + 7) the transverse inclination of the saw frame
can be corrected. However, make sure first that the machine frame is aligned correctly.
5) If the position the saw bow correctly, tighten the 6 screws on professionally.
6) Hook the springs into the holes of the brackets (8).
7) Check the mobility of the bow. If necessary adjust the stops of the saw bow (see
8) Start machine as described in See "Initial operation" on page 30
9) Perform a test cut and check the result.
10) If necessary, correct your settings. Disconnect the machine from the power supply nec-
essarily.
6.4.2 Place machine
1) Transport the BSM 630 to the setup location (see Chap. 5.3 on p. 23).
2) During setup pay attention to the required horizontal and vertical spacing (see Chap. 6.3 on
p. 26).
3) Lift the BSM 630 with a suitable transportation device.
4) Screw all supplied screw feet from below about half-way into the threaded holes of the
machine frame (see Chap. 4. on p. 19).
5) Remove the underlying wooden blocks.
6) Slowly place the BSM 630 on the ground until it fully rests on the screw feet.
7) Horizontally align the machine frame lengthwise and across with a water level. The slope of
the machine frame can be adjusted by screwing the machine feet in or out.
8) Ensure that all screw feet are resting fully on the ground.
9) Secure the screw feet with the fitted locknut. This concludes machine setup.
10) If necessary mount saw bow.
11) Thus the installation of the machine is complete.
BSM 630