RIEXINGER BSM 630, Руководство по эксплуатации

Страница: 53 / 70

9. Maintenance 51
4) Operator and assisting person are required to wear work gloves and safety glasses.
5) Carefully pull off the saw band from the diversion wheels (see image in Chap. 9.4 ).
6) Carefully pull off the saw band from the front and back saw-band guide and remove it.
Warning!
Coiling up the old saw band poses an injury risk - especially for the facial
area!
Operator and assisting person must be especially careful and wear protective
glasses.
7) Coil up the old saw band to safely dispose of it.
8) Remove all saw dust with a brush or vacuum cleaner from where the saw band used to run.
The installation of a new saw band is explained in Chap. 9.4 .
9.4 Inserting the saw band
Danger!
Running saw band may cause serious severance injury!
The assisting person mentioned below may only enter the hazard- or working
area after deactivating the machine with the main switch.
Danger!
Climbing onto the machine poses a fall- and injury risk due to sharp machine
parts!
It is not permissible to climb onto the machine when performing maintenance- or
any other kind of work. Use suitable climbing aids (e.g. stepladders or multi-pur-
pose ladders, but no leaning ladders).
Attention!
After sawing the hot saw band may burn the operator!
The saw band poses an injury risk!
Always wear protective gloves when working on the saw band.
1) If you have not already done so, execute the steps in Chap. 9. on p. 47 .
2) If the covers of the saw band have not already been removed, do so (see Chap. 9.3 on p. 50).
3) Operator and assisting person are required to wear work gloves and safety glasses.
BSM 630