1 October, 1999
PRINTER ENGINE SERVICE MODE
4-13
Service
Tables
Menu Level
Level 1
Level 2
Description
Function
Settings
M:
Tailing
cntrl
Tailing
Correction
(Shift Value)
Shifts the image across the
page at the interval specified
by the following SP mode (N:
Tailing papers).
When making many copies of
an original that contains
vertical lines (such as a table),
separation may not work
correctly, then a tailing image
will occur (ghosts of the
vertical lines will continue past
the bottom of the table). This
SP prevents this problem.
0.0 to 5.0
0.1
mm/step
0.0 mm
N:
Tailing
papers
Tailing
Correction
(Interval)
Changes the interval for the
image shift specified by the
previous SP mode (M: Tailing
cntrl).
1 to 10
1 page/step
1 page
O:
Toner
supply
Toner Supply
Mode
Selects the toner supply mode.
Important:
Normally, only use “P+T
Control” setting. Change to
“T Control” temporarily if the
TD sensor is defective. Do not
use other settings; these are
for designer’s use only.
P+T
Control
Fixed 1
Fixed 2
T Control
P:
T sensor
set
Standard Vt
Adjusts Vts (Vt for a new
PCU). The TD sensor output is
adjusted to this value during
the TD sensor initial setting
process.
This SP is not effective when
“T Control” of the previous SP
mode (O: Toner supply) is
selected.
Important: Do not change
this value.
0.00 to 5.00
0.01 V/step
2.30 V
