12
Rev 20A
Step 5 - Fitting mounting Plate & Motor:
•
Fit motor mounting plate back into place and fit and tighten anchor bolts (as per
figures 7 and 8).
•
Fit motor back on mounting plate, ensuring the power cord is positioned into the end
slot of the mounting plate in the direction of the power point, making sure there are no
pinch points (as per fig 9).
•
Slide rubber grommet along the power lead and into the end slot of the mounting
plate (as per figures 10 & 11).
•
Bolt motor to the mounting plate using the M8 x 50mm bolts with spring and flat
washers provided and tighten as required (as per figure 12).
Fig 9
Fig 10
Fig 11
Fig 12
Insert the M8 x 50mm bolts
(Part 6d), spring washers, and flat
washers provided through motor
housing and screw into welded
nut on the baseplate.
Hand-tighten set screws before
final adjustment of motor.
Tighten bolts using
spanner or socket set
Fig 7
Fig 8
