11
Rev 20A
Step 3 - Motor Position installation:
•
Insert the key and open the manual release bar to put the motor into manual mode,
and check that the motor cog rotates freely by hand (As per Fig 15).
•
Place the motor and motor mounting plate on the concrete pad.
•
Make sure the distance between the gate motor cog and gear rack position are
aligned.
•
Mark all four corners of the mounting plate on the concrete pad using a pencil, chalk
or similar, to ensure the mounting plate is in the correct position before drilling.
•
Remove motor from the mounting plate.
Step 4 - Drilling holes for anchor bolts:
•
Mark the (4) positions for your anchor bolts ready for drilling (refer to Fig 5).
•
Remove Mounting plate.
•
Using a M12 masonry drill bit, drill holes to a minimum depth of 120mm (Fig 6).
Mark anchor bolt positions
Fig 5
Fig 6
Mark
corners
of the
mounting
plate with
a pencil,
chalk, or
similar.
Sliding Gate Frame
Fig 4
Fig 3
