17
Rev 20A
Step 8 - Powering the Motor:
•
Ensure that the outer cover has been fitted and fastened back onto the motor
housing.
•
Before powering up the motor make sure the gate can travel by hand in manual
mode (key unlocked).
•
Slide the gate to between the middle of the posts, approximately.
•
Lock the key (key locked) in readiness for automatic mode.
•
Plug the power cord into an approved RCD protected weatherproof outlet.
•
Remote controls (Part 4) included in this kit are factory paired ready for use.
Note:
•
The default setting is opening to the right.
•
Press the remote control and the gate will open until the magnetic limit travel stop
passes the magnetic limit switch sensor. Press the remote control again and the
gate will close.
•
Soft start/soft stop function - The GTR064 is set by default to provide the soft
start/soft stop function. We recommend this default position is always maintained.
Your motor is now set up for basic remote-control operation. To set further functions
and settings, see pages 19-32
